Bill Miracle
New
In a previous message, you gave your address checklist. Here it is:
Address check list:
1.left wrist on top of shaft
2.left wrist paralell to the leading edge of te clubface (for straight shot)
3.shaft points to center of hips
elbows point at their respective hips
4.spine angle and tilt (established according to club being used)
5.shoulders, hips, knees, feet paralell to taget line.
In reference to no. 4, how do you determine the spine angle and tilt (I assume right tilt)????
I am reconstucting my alignment and address. I have a right shoulder that tilts TOO MUCH and forward pressing hands at address.
I am really focusing on Brian's setup article and striving to achieve a consistent and solid setup routine with good alignments.
Concerning consistency....how do I know which clubs to open the stance on? Usually I do this on wedges...maybe a little on 9 iron. Should I open my stance for these clubs?
How do I know which clubs to employ a little more right tilt at address? (I assume I should do this on the driver a bit). When do I give more...or less spine angle?
Address check list:
1.left wrist on top of shaft
2.left wrist paralell to the leading edge of te clubface (for straight shot)
3.shaft points to center of hips
elbows point at their respective hips
4.spine angle and tilt (established according to club being used)
5.shoulders, hips, knees, feet paralell to taget line.
In reference to no. 4, how do you determine the spine angle and tilt (I assume right tilt)????
I am reconstucting my alignment and address. I have a right shoulder that tilts TOO MUCH and forward pressing hands at address.
I am really focusing on Brian's setup article and striving to achieve a consistent and solid setup routine with good alignments.
Concerning consistency....how do I know which clubs to open the stance on? Usually I do this on wedges...maybe a little on 9 iron. Should I open my stance for these clubs?
How do I know which clubs to employ a little more right tilt at address? (I assume I should do this on the driver a bit). When do I give more...or less spine angle?